A warning message will be displayed if you attempt to deactivate the Guided Access session while taking an assessment ignoring this warning message will automatically submit your assessment at whatever point you were at when you deactivated the session, i.e., you will not be able to complete any unanswered portions of the assessment. Deactivating the Guided Access session will automatically submit your assessment. Warning: When taking a Questionmark Secure assessment on your iPad, it is important that you do not deactivate the Guided Access session. You can now exit the Questionmark Secure for iPad app. Tap the End button in the upper left-hand corner.Enter your four-digit Guided Access passcode to deactivate the Guided Access session.Once you've completed and submitted the assessment, you'll receive a message stating that you've completed the assessment, and at this point you can deactivate the Guided Access session.A Guided Access session is now running, and the assessment will now launch. Tap the Start button in the upper right-hand corner.If you haven't already enabled the Guided Access feature on your iPad, see Enabling Guided Access for instructions. You'll see an error message pop up that states a Guided Access session needs to be activated before the assessment will launch. Tap a URL that links to a Questionmark Secure assessment (this might be on a website, in an email or text message, from an LMS portal, etc.).
To launch a secure assessment on an iPad:
#Guided access for mac Pc#
Like the PC and Mac versions of Questionmark Secure, Questionmark Secure for iPad will open automatically whenever your iPad encounters secure Questionmark content. For information on downloading and installing Questionmark Secure for iPad, see Installing Questionmark Secure for iPad. If you do this, change the settings back from a wired PC, or reset the router using the reset button, which will wipe all settings.With Questionmark Secure for iPad, you can take Questionmark Secure assessments on an iPad. Don't forget to click Add before you click OK, as if you press OK first, the MAC address isn't in the access list yet and you'll enable access control with no clients, so you'll lock yourself out (wireless interface only -wired clients won't be affectved). Once you enable the feature, only clients with those MAC addresses :Įnter the MAC address into the boxes and then press the Add button. Next, in the router's Wireless LAN, Access Control menu, you just need to tick to enable the feature and then add in one or more MAC addresses. If you have more than one Ethernet interface on the PC, make sure you select the MAC address from the right one. Note down the MAC address (circled red above) it is six hexadecimal digits.
#Guided access for mac windows#
This can be discovered by using the ipconfig /all command from the Windows Command prompt : Firstly, you need to find out the Wireless Client Adaptor's MAC address. The MAC address is fixed (you can change it on some adaptors, but this should only be done in specific circumstances, and not here!).īy setting up an access list on the Vigor, you can restrict access to the wireless interface only to those wireless clients you specify. The MAC address is not the same as the IP address (which is at a higher layer). This is used by the LAN to identify each client uniquely in order to switch packets correctly. You can also turn on Face ID or Touch ID as a way to end a Guided Access session.
Adjust any of the following: Passcode Settings: Tap Set Guided Access Passcode, then enter a passcode. By default, WEP is turned off on the router.Īll Ethernet card, including wired and wireless types have a unique hardware 'ID' called a MAC address. Go to Settings > Accessibility > Guided Access, then turn on Guided Access. WEP (Wireless Encryption Protocol) is an method of data encryption for wireless clients, which makes the sending of your data over the wireless interface more secure.
0 kommentar(er)
